A 10-Point Plan for (Without Being Overwhelmed)

The Best Tips on How You Can Replace a Windshield

After a simple chip or crack on the windshield, what is going to happen is that the chip or crack will keep growing and therefore make your windshield unattractive and dangerous. After you take your car for repair and to be fitted with a new windshield, you’ll find that it is expensive and for this reason, you should teach yourself how to replace the windshield. By reading this article, you will discover more about the most useful tips on how to replace the windshield.

The first step to take is to remove the old damaged windshield from your vehicle. To remove the old damaged windshield, remove the rubber trim, then peel the gasket from the groove around the glass and finally remove the clips that keep the molding place. What you should do next is separate the windshield glass using a razor from the pinch weld so that you separate the windshield from the urethane seal. To cut the urethane seal might be a challenge to you because it is very strong and adhesive. Ensure that you cut it from inside so that your careful not to break the glass since it can cause a mess. The next thing is to lift the windshield and it is important that you seek help because it is a two-person job. After removing the glass, place it carefully on top of a towel that is on the ground. This is going to avoid the mess of shattered glass where you have parked your vehicle or in the garage.

Before installing the new windshield, you should prepare the pinch-weld by using sandpaper to remove rust from it, passing water on it and then brushing it to clean away contaminants. You should then apply a layer of urethane primer to the black band that is around the perimeter of the windshield to prepare for the installation of the new windshield. To read more about how you can install your new windshield, visit the website of Windshield Guru.

Give about 24 hours for urethane dry before you can start driving again. The next step is to install the window gasket and you should start from one end and press it into the groove until you complete the whole perimeter of the windshield. The final step is for you to replace the trim around the windshield only if urethane has dried completely. If you follow the above steps, then you are going to replace your windshield within no time. If you are interested in reading other DIY windshield replacement tips, ensure that you visit this website.